XTP R HD 4K 用于 HDMI 信号的 XTP 4K 接收器-智慧城市网

产品详情

Extron XTP R HD 4K 是一款接收器，可通过单根 CATx 屏蔽电缆延长视频、音频、双向控制和以太网信号。这款符合 HDCP 2.2 标准的接收器支持分辨率高达 4K 的视频信号。为了简化集成，它提供了可选的 HDMI 音频直通、音频解嵌至数字 S/PDIF 或模拟立体声音频输出以及用于房间控制的继电器。以太网扩展及双向 RS-232 和红外插入功能方便了局域网接入和远程视音频设备控制。通过屏蔽双绞线电缆可将信号传输至 100 m (330') 远的距离。XTP R HD 4K 支持远程供电，是需要将信号长距离传输至显示器和其它输出设备的 XTP Systems® 的理想之选。

特性

通过单根 CATx 屏蔽电缆在 100 m（330') 远的距离上接收带嵌入音频的视频、双向 RS-232 和红外及以太网信号

支持分辨率高达 4K 的计算机和视频信号

用于视音频设备控制的双向 RS-232 和红外插入

符合 HDCP 2.2 标准

HDCP 可视确认 — 当处理 HDCP 加密的内容时，如果视频输出连接至一个不符合 HDCP 标准的显示设备，图像解析度转换器即会输出一个全屏的绿色信号，可以从视觉上立刻确认被保护内容无法显示在此显示设备上

支持远程供电

强烈建议使用 Extron XTP DTP 24 屏蔽双绞线电缆，以达到的性能表现

支持 HDMI 参数标准，包括高达 10.2 Gbps 的数据速率、高达 12 位的色深、3D 和高清无损的音频格式

全面的 EDID 管理 — 过 XTP System Configuration 软件访问 EDID Minder，用于设置视频输入 EDID、捕获来自连接显示设备的 EDID 或上传定制的 EDID 文件。正确的 EDID 管理确保信号源和显示设备能轻松地集成至系统中，从而实现优化的系统操作。可免费下载 EDID Manager 2.0 软件，以提供高级 EDID 编辑及创建定制的 EDID 文件。

EDID 管理器 (EDID Minder®) 自动地管理已连接设备之间的 EDID 通信

密钥管理器 (Key Mindersup>®) 持续地验证 HDCP 标准，用于快速、可靠的切换

以太网扩展

HDMI 音频解嵌，带模拟立体声和数字 S/PDIF 音频输出

音频输出音量调节和*功能

可选的 HDMI 音频直通

2 个继电器，用于控制房间功能

兼容所有的 XTP 产品

经 JITC 认证

随附外置 Extron Everlast™ 电源，产品编号 #70-1174-01 — 该通用型电源具有经验证的高可靠性和低功耗，能够降低运行成本

Extron Everlast 电源可享受 7 年部件及人工保修

Video
Gain	Unity
Resolution range	Up to 2560x1600 @ 60 Hz* or 4K (4096x2160) @ 30 Hz, UHD (3840x2160) @ 30 Hz, 4K/UHD @ 60 Hz with 4:2:0 chroma subsampling * reduced blanking
Signal type	Single-link HDMI (or DVI-D or DisplayPort)
Maximum data rate	10.2 Gbps (3.4 Gbps per color)
Maximum pixel clock	300 MHz (600 MHz for 4K rates with 4:2:0 chroma subsampling)
Formats	RGB and YCbCr digital video
Standards	DisplayPort 1.1, DVI 1.0, HDMI 1.4; HDCP 2.2

Interconnection between transmitter and receiver
Connectors	1 female RJ-45 per unit
Termination standards	TIA/EIA T568B
Signal transmission distance	330' (100 m) using shielded twisted pair or XTP DTP 24 cable
Cable requirements	Solid conductor, 24 AWG or better
Cable recommendations	400 MHz bandwidth, STP (Shielded Twisted Pair)
NOTE Extron XTP DTP 24 shielded twisted pair cable is strongly recommended for optimal performance.

Video output
Number/signal type	1 single link HDMI (or DVI-D)
Connectors	1 female HDMI type A

Audio
Gain	Unbalanced output: 0 dB; balanced output: +6 dB
Frequency response	20 Hz to 20 kHz, ±0.05 dB
THD + Noise	<0.1% @ 20 Hz - 20 kHz at nominal level
S/N	>90 dB, at maximum balanced output (unweighted)
Crosstalk	≤-80 dB @ 1 kHz, fully loaded
Stereo channel separation	>80 dB @ 1 kHz
Sampling rates	32 kHz, 44.1 kHz, 48 kHz, 96 kHz, 192 kHz
Bit depths	16, 20, 24 bit

Audio output
Number/signal type	1 analog stereo (2-channel), balanced/unbalanced 1 digital audio, embedded with HDMI output 1 digital audio via S/PDIF output connector
Connectors	(1) 3.5 mm captive screw connector, 5 pole 1 female HDMI type A (shared with video output) 1 female RCA jack (tip, ring)
Supported formats
HDMI	LPCM up to 7.1/24-bit/192 kHz, Dolby Atmos®, Dolby® TrueHD, Dolby Digital Plus™, Dolby Digital EX, Dolby Digital 5.1, Dolby Digital 2/0 Surround, Dolby Digital 2/0, DTS-HD Master Audio™, DTS-HD, DTS-ES Discrete 6.1, DTS-ES Matrix 6.1, DTS Digital Surround 5.1, DTS 2 Channel
S/PDIF	LPCM up to 7.1/24-bit/192 kHz, Dolby Digital EX, Dolby Digital 5.1, Dolby Digital 2/0 Surround, Dolby Digital 2/0, DTS-ES Discrete 6.1, DTS-ES Matrix 6.1, DTS Digital Surround 5.1, DTS 2 Channel
Analog	Analog stereo audio
Impedance
Analog	50 ohms unbalanced, 100 ohms balanced
Digital	75 ohms (for S/PDIF output)
Maximum level (Hi-Z)	>+12 dBV balanced; +6 dBV unbalanced
Gain error	±0.5 dB channel to channel
Volume control range	-100 dB to 0 dB (control 0 to 100 in 1 dB steps)
NOTE Attenuation = volume number minus 64. The default is 0 dB = volume number 64.
NOTE 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu

Communications — receiver
USB control ports	1 front panel female mini USB B
USB standards	USB 2.0, low speed
Program control	Extron control/configuration program for Windows® Extron Simple Instruction Set (SIS™)

Communications — external device (pass-through, unidirectional or bidirectional)
Serial control port input/output	1 set of proprietary signals on a female RJ-45 jack
Serial control port output/input	RS-232 (+5) via (1) 3.5 mm, 5-pole captive screw connector (uses 3 poles) (connector is shared with IR control port)
Baud rates	Up to 115200 baud
Protocol	Data bits = 5 - 8 Stop bits = 1 or 2 Parity = odd, even, none Flow control = XON, XOFF, none
Serial control pin configuration	1 = Tx, 2 = Rx, 3 = Gnd
IR control port	(1) 3.5 mm, captive screw connector, 5 pole (connector is shared with RS-232 control port) TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 56 kHz
IR control pin configuration	3 = Gnd, 4 = IR Tx, 5 = IR Rx
Ethernet pass-through port	1 female RJ-45 connector
Ethernet data rate	10/100Base-T, half/full duplex with autodetect
Relay number/type	2 normally open relays
Relay control connectors	(1) 3.5 mm captive screw connectors, 4 pole
Relay control contact rating	24 V, 1 A

General
Power supply	External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 1.5 A, 18 watts
Power consumption
Device	9.1 watts, 12 VDC
Device and power supply	11.3 watts, 12 VDC
NOTE The XTP receiver can be powered either locally by an external power supply or remotely using an optional power injector or XTP CrossPoint matrix switcher.
Temperature/humidity	Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Cooling	Convection, vents on sides and top
Thermal dissipation
Device	30.0 BTU/hr
Device and power supply	37.6 BTU/hr
Mounting
Rack mount	Yes, with optional 1U high rack shelf
Furniture mount	Yes, with optional under-desk mounting kit
Enclosure type	Metal
Enclosure dimensions	1.0" H x 8.68" W x 6.0" D (half rack wide) (2.5 cm H x 22.1 cm W x 15.2 cm D) (Depth excludes connectors.)
Product weight	1.6 lbs (0.7 kg)
Vibration	ISTA 1A in carton (International Safe Transit Association)
Regulatory compliance
Safety	CE, c-UL, UL
EMI/EMC	CE, C-tick, FCC Class A, ICES, VCCI
Environmental	Complies with the appropriate requirements of RoHS, WEEE.
NOTE **CE and FCC testing is conducted with STP (shielded twisted pair) cable.
Product warranty	3 years parts and labor
Everlast power supply warranty	7 years parts and labor
NOTE All nominal levels are at ±10%.
NOTE Specifications are subject to change without notice.